Liberty 4WD V6-3.7L (2009)
Wheel Speed Sensor: Service and Repair
Wheel Speed Sensor - Installation
Front
INSTALLATION
NOTE: When installing, do not rotate sensor, as this may cause the sensor to rub on the tone ring and be damaged.
1. Install the wheel speed sensor to the vehicle.
2. Install the wheel speed sensor (1) through the brake shield and to the hub/bearing (3).
3. Install the wheel speed sensor wire hold down routing clips.
4. Install the wheel speed sensor mounting bolt (2) to the hub (3). Tighten the mounting bolt to 8 Nm (71 in. lbs.).
5. Install the disc brake rotor See: Brakes and Traction Control/Disc Brake System/Brake Rotor/Disc/Service and Repair/Removal and
Replacement/Brake Rotor - Installation.
6. Install the disc brake caliper adapter. See: Brakes and Traction Control/Disc Brake System/Brake Caliper/Service and Repair/Removal and
Replacement/Disc Brake Caliper Adapter - Installation.
7. Install the tire and wheel assembly See: Maintenance/Wheels and Tires/Service and Repair/Removal and Replacement.
Rear
INSTALLATION
1. Insert the wheel speed sensor through the support plate.
2. Tighten the wheel speed sensor bolt (2) to 9 Nm (80 in. lbs.).
3. Secure the wheel speed sensor wire to the routing clips. Verify that the sensor wire is secure and clear of the rotating components.
4. Reconnect the wheel speed sensor electrical connector (1).