Liberty 4WD V6-3.7L (2009)
Cruise Control Switch: Service and Repair
Speed Control Switch - Installation
INSTALLATION
Mounting hole (1) uses a screw. Depending on model line, mounting holes (2) may use either two screws, or one screw and a locating pin.
1. Connect electrical connector to speed control switch.
2. Install speed control switch mounting screws.
3. Tighten screws (1) to 1.6 Nm (15 in. lbs.). Make sure rubber seal is in place around switch.
4. Install horn switch.
5. Install three mounting fasteners.
6. Connect electrical connector to clockspring.
