Liberty 4WD V6-3.7L (2009)
Power Steering Fluid: Service and Repair
POWER STEERING FLUID LEVEL CHECKING
WARNING: The fluid level should be checked with engine off to prevent injury from moving components.
CAUTION: MOPAR(R) ATF+4 is to be used in the power steering system. No other power steering or automatic transmission fluid is to be
used in the system. Damage may result to the power steering pump and system if any other fluid is used, and do not overfill.
NOTE: Power steering reservoir does not contain a dipstick. Fluid level indicators are molded into the side of the reservoir WITH REMOTE
RESERVOIR.
The power steering fluid level can be viewed on the dipstick attached to the filler cap. Before opening power steering system, wipe the reservoir filler
cap free of dirt and debris. Remove the cap and check the fluid level on its dipstick. When the fluid is at normal ambient temperature, approximately 21°
C to 27°C (70°F to 80°F), the fluid level should read between the minimum and maximum on dipstick (GAS) or Reservoir (DIESEL). Only add fluid
when the vehicle is cold.
Use only Mopar(R) ATF+4 . Do not overfill the power steering system.
