Liberty 4WD V6-3.7L (2009)
Do not exceed minimum tightening torque 217 Nm (160 ft. lbs.) at this point.
5. Rotate pinion several times and verify pinion rotates smoothly.
6. Measure pinion torque to rotate (1) with an inch pound torque wrench (2). Pinion torque to rotating should be equal to recorded reading plus 0.56
Nm (5 in. lbs.).
If rotating torque is low, tighten the pinion nut in 6.8 Nm (5 ft. lbs.) increments until proper rotating torque is achieved.
CAUTION: If maximum tightening torque is reached 352 Nm (260 ft. lbs.) prior to reaching required rotating torque, the collapsible spacer
may have been damaged.Never loosen pinion nut to decrease pinion rotating torque and never exceed specified preload torque. Failure to
follow these instructions will result in damage.
7. Install brake rotors, calipers and propeller shaft.
8. Fill differential with gear lubricant.
