Liberty 4WD V6-3.7L (2009)
Wiper Motor: Service and Repair
Wiper Motor - Installation
INSTALLATION
1. If the output shaft bezel and grommet (1) were removed from the outside of the liftgate, install the rubber bezel and grommet into the rear wiper
motor output shaft clearance hole of the liftgate outer panel.
2. Position the rear wiper motor and bracket unit (2) onto the liftgate inner panel as a unit.
3. Install and tighten the three screws (3) that secure the mounting bracket to the liftgate. Tighten the screws to 5.5 Nm (49 in. lbs.).
4. Reconnect the wire harness connector to the motor connector receptacle.
5. Reinstall the trim panel onto the liftgate inner panel. See: Body and Frame/Doors, Hood and Trunk/Trunk / Liftgate/Trunk / Liftgate Interior Trim
Panel/Service and Repair/Liftgate Trim Panel - Installation.
6. Reinstall the rear wiper arm onto the output shaft. See: Wiper Arm/Service and Repair/Wiper Arm - Installation.
7. Reconnect the battery negative cable.