Liberty 4WD V6-3.7L VIN K (2003)
Fig.2 SRS Logo
Optional side curtain airbags are available for this model when it is also equipped with dual front airbags. These airbags are passive, inflatable,
Supplemental Restraint System (SRS) components, and vehicles with this equipment can be readily identified by a molded identification trim
button with the "SRS - AIRBAG" logo located on the headliner above each B-pillar. This system is designed to reduce injuries to the vehicle
occupants in the event of a side impact collision.
Fig.37 Side Curtain Airbag
Vehicles equipped with side curtain airbags have two individually controlled curtain airbag units. These airbag units are concealed and mounted
above the headliner where they are each secured to one of the roof side rails. Each folded airbag cushion is contained within a long extruded
plastic channel that extends along the roof rail from the A-pillar at the front of the vehicle to just behind the C-pillar at the rear of the vehicle. The
channel is secured with plastic push-in fasteners to the roof rail. A tether extends down the A-pillar from the front of the airbag cushion, where it is
retained to the pillar with plastic push-in routing clips and it is secured to the base of the A-pillar near the belt line with a screw.
The hybrid-type inflator for each airbag is secured to the roof rail at the rear of the airbag unit between the C-pillar and the D-pillar, and is
connected to the airbag cushion by a long tubular manifold. The bracket holding the inflator and three other brackets holding the manifold are
secured to the roof rail with screws. A two-wire pigtail harness is routed forward from the airbag inflator through a trough along the top of the
