Liberty Limited Edition 2WD V6-3.7L VIN K (2002)
The rear washer nozzle is a fluidic-type unit constructed of molded plastic. The nozzle is secured by a snap fit in a dedicated mounting hole
located in the rear edge of the roof panel above the rear flip-up glass opening and to the right of the Center High Mounted Stop Lamp (CHMSL)
unit. A rubber gasket on the back of the nozzle seals the nozzle to the roof panel opening. The back of the nozzle includes an integral alignment
feature on the left side, an integral engagement tab on the top, an integral latch feature on the bottom, and the washer plumbing nipple which are
all concealed between the outer roof panel and the rear roof inner header. The rear washer nozzle latch feature is a one time component, and will
be damaged if the nozzle is removed from its mounting hole for service. The rear washer nozzle cannot be adjusted or repaired. If faulty or
damaged, the entire nozzle unit must be replaced.
The rear washer nozzle is designed to dispense washer fluid into the wiper pattern area on the outside of the rear flip-up glass. Pressurized washer
fluid is fed to the nozzle from the washer reservoir by the washer pump/motor through a single hose, which is attached to a barbed nipple on the
back of the rear washer nozzle. The rear washer nozzle incorporates a fluidic design, which causes the nozzle to emit the pressurized washer fluid
as an oscillating stream to more effectively cover a larger area of the glass area to be cleaned.
