Liberty Sport 2WD L4-2.4L VIN 1 (2002)
Hydraulic Control Assembly - Antilock Brakes: Service and Repair
REMOVAL
1. Install prop rod on the brake pedal to keep pressure on the brake system.
2. Remove negative battery cable from the battery.
3. Pull up on the CAB harness connector release and remove connector.
4. Remove brake lines from the HCU.
5. Remove HCU/CAB mounting nuts and boll and remove HCU/CAB.
INSTALLATION
1. Install HCU/CAB on the mounting studs.
2. Install mounting nuts and bolt. Tighten to 11.5 Nm (102 inch lbs.).
3. Install brake lines to the HCU and tighten to 19 Nm (170 inch lbs.).
4. Install wiring harness connector to the CAB and push down on the release to secure the connector.
5. Install negative battery cable to the battery.
6. Bleed ABS brake system.