Liberty Sport 2WD L4-2.4L VIN 1 (2002)
Brake Caliper: Service and Repair
Disc Brake Caliper Adapter
DISC BRAKE CALIPER ADAPTER
REMOVAL
1. Raise and support the vehicle.
2. Remove the front wheel and tire assembly.
3. Drain a small amount of fluid from master cylinder brake reservoir with a clean suction gun.
4. Bottom the caliper pistons into the caliper by prying the caliper over.
5. Remove the caliper mounting bolts.
6. Remove the disc brake caliper from the mount.
CAUTION: Never allow the disc brake caliper to hang from the brake hose. Damage to the brake hose will result. Provide a suitable support to
hang the caliper securely.
7. Remove the inboard and outboard brake pads.
8. Remove the caliper adapter mounting bolts.
INSTALLATION
1. Install the caliper adapter mounting bolts. Tighten the mounting bolts to 135 Nm (100 ft. lbs).
2. Install the inboard and outboard pads.
3. Install the caliper mounting bolts.
4. Install the tire and wheel assembly.
