Liberty Sport 2WD L4-2.4L VIN 1 (2002)
Brake Master Cylinder: Service and Repair
Fluid Reservoir Removal and Installation
FLUID RESERVOIR
REMOVAL
1. Install prop rod on brake pedal to keep pressure on the brake system.
2. Remove reservoir cap and siphon fluid into drain container.
3. Remove the electrical connector from the fluid level switch in the reservoir.
4. Remove the reservoir mounting bolt.
5. Remove the reservoir from the master cylinder by pulling upwards.
6. Remove old grommets from cylinder body.
INSTALLATION
1. Fill and bleed master cylinder on bench before installation in vehicle.
CAUTION: Do not use any type of tool to install the grommets. Tools may cut, or tear the grommets creating a leak problem after installation.
Install the grommets using finger pressure only.
2. Lubricate new grommets with clean brake fluid and Install new grommets in cylinder body. Use finger pressure to install and seat grommets.
3. Start reservoir in grommets. Then rock reservoir back and forth while pressing downward to seat it in grommets.
4. Install the mounting bolt for the reservoir to the master cylinder.
5. Reconnect the electrical connector to the fluid reservoir level switch.
6. Remove the prop rod from the vehicle.
7. Fill and bleed base brake system.
