Liberty Sport 2WD L4-2.4L VIN 1 (2002)
Hydraulic System Junction Block: Service and Repair
BRAKE JUNCTION BLOCK
REMOVAL
1. Install prop rod on the brake pedal to keep pressure on the brake system.
2. Remove the brake lines from the junction block.
3. Remove mounting nuts and bolt and remove the junction block.
INSTALLATION
1. Install the junction block on the mounting studs.
2. Install mounting nuts and bolt. Tighten to 14 Nm (125 in. lbs.).
3. Install brake lines to the junction block and tighten to 20 Nm (180 in. lbs.).
4. Bleed the brake system.