Liberty Sport 2WD L4-2.4L VIN 1 (2002)
corrosion. Replace the pistons if worn, scored, or corroded. Do not attempt to restore the surface by sanding or polishing.
Discard the old piston cups and the spring and expander. These parts are not reusable. The original dust boots may be reused but only if they are in
good condition.
ASSEMBLY
1. Lubricate wheel cylinder bore, pistons, piston cups and spring and expander with clean brake fluid.
2. Install first piston in cylinder bore. Then install first cup in bore and against piston. Be sure lip of piston cup is facing inward (toward spring and
expander) and flat side is against piston.
3. Install spring and expander followed by remaining piston cup and piston.
4. Install boots on each end of cylinder and insert push rods in boots.
5. Install cylinder bleed screw.
INSTALLATION
1. Install cylinder mounting bolts and tighten to 20 Nm (15 ft. lbs.).
2. Connect brake line to cylinder and tighten to 14 Nm (124 inch lbs.).
3. Install the brake shoe return springs.
4. Remove the brake pedal prop rod.
5. Install the brake drum.
6. Install the wheel and tire assembly.
7. Bleed base brake system.
