Liberty Sport 2WD L4-2.4L VIN 1 (2002)
4. Disconnect the two cables from the front mount .
5. Pull the carpet forward far enough in the rear to gain access to the two parking brake cables through the floor.
6. Push the cables through the floor with the grommets.
7. Remove the primary brake shoe hold down spring and separate the shoes to gain access, Then disconnect the cable from lever on brake shoe.
8. Remove cables from backing plates by using a screw driver to break off the tangs on the cable or a proper sized box end wrench over the tangs.
INSTALLATION
1. Install the cables into the support plate.
2. Reconnect the cable to the lever on the brake shoe, Install the primary brake shoe hold down spring and the shoes.
3. Push the cables through the floor and seat the grommets.
4. Reconnect the two cables to the front mount.
