Liberty Sport 2WD L4-2.4L VIN 1 (2002)
Cruise Control Servo Cable: Service and Repair
REMOVAL
1. Disconnect negative battery cable at battery.
2. Remove air filter resonator at throttle body.
The accelerator cable must be partially removed to gain access to speed control cable.
Fig.1 Throttle Cable Pin
Fig.2 Throttle Cable Release Tab
3. Hold throttle in wide open position. While held in this position, slide throttle cable pin from throttle body bellcrank.
4. Using a pick or small screwdriver, press release tab to release plastic cable mount from bracket. Press on tab only enough to release cable from
bracket. If tab is pressed too much, it will be broken. Slide plastic mount towards right side of vehicle to remove throttle cable from throttle body
bracket.
