Liberty Sport 2WD L4-2.4L VIN 1 (2002)
Fig.3 Speed Control Cable At Bellcrank
5. Using finger pressure only disconnect servo cable connector at throttle body bellcrank pin by pushing connector off bellcrank pin towards front of
vehicle. DO NOT try to pull connector off perpendicular to the bellcrank pin. Connector will be broken.
Fig.4 Speed Control Cable At Bracket
6. Slide speed control cable plastic mount towards right of vehicle to remove cable from throttle body bracket.
7. Remove servo cable from servo. Refer to Servo Removal/Installation.
INSTALLATION
1. Install end of cable to speed control servo. Refer to Servo Removal/Installation.
2. Slide speed control cable plastic mount into throttle body bracket.
3. Install speed control cable connector onto throttle body bellcrank pin (push rearward to snap into location).
4. Slide throttle (accelerator) cable plastic mount into throttle body bracket. Continue sliding until cable release tab is aligned to hole in throttle body
mounting bracket.
5. While holding throttle to wide open position, place throttle cable pin into throttle body bellcrank.
6. Install air filter resonator box to throttle body.
7. Connect negative battery cable at battery.
8. Before starting engine, operate accelerator pedal to check for any binding.
