Liberty Sport 2WD L4-2.4L VIN 1 (2002)
Fig.3 Console Duct Remove/Install
2. Remove the floor console from the sled. Refer to Floor Console for the procedures.
3. Lift the rear of the console duct out of the console rear mounting bracket on the sled and slide the duct rearward to disengage it from the floor duct
and adapter.
4. Remove the console rear duct from the vehicle.
INSTALLATION
1. Push the console duct forward in place on the HVAC floor duct.
2. Align the rear tab of the console duct with the hole on the sled bracket.
3. Insert the push pin in the hole on the sled.
4. Install the floor console on the floor panel transmission tunnel.
5. Connect the battery negative cable.
Floor Distribution Ducts Replacement
REMOVAL
WARNING: ON VEHICLES EQUIPPED WITH AIRBAGS, DISABLE THE AIRBAG SYSTEM BEFORE ATTEMPTING ANY
STEERING WHEEL, STEERING COLUMN, OR INSTRUMENT PANEL COMPONENT DIAGNOSIS OR SERVICE. DISCONNECT
AND ISOLATE THE BATTERY NEGATIVE (GROUND) CABLE, THEN WAIT TWO MINUTES FOR THE AIRBAG SYSTEM
CAPACITOR TO DISCHARGE BEFORE PERFORMING FURTHER DIAGNOSIS OR SERVICE. THIS IS THE ONLY SURE WAY TO
DISABLE THE AIRBAG SYSTEM. FAILURE TO TAKE THE PROPER PRECAUTIONS COULD RESULT IN AN ACCIDENTAL
AIRBAG DEPLOYMENT AND POSSIBLE PERSONAL INJURY.
1. Remove the instrument panel from the vehicle. Refer to: Body and Frame, Interior Trim, Dashboard/Instrument Panel, Service and Repair,
Instrument Panel Assembly Replacement, See: Body and Frame/Interior Moulding / Trim/Dashboard / Instrument Panel/Service and
Repair/Instrument Panel Assembly
2. Remove the three screws that secure the floor duct to the HVAC housing.
3. Remove the floor duct from the HVAC housing.
INSTALLATION
1. Install the floor duct on the HVAC housing.
2. Install the three screws that secure the floor duct to the HVAC housing. Tighten the mounting screws to 2.2 Nm (20 in. lbs.).
3. Install the instrument panel in the vehicle. Refer to: Body and Frame, Interior Trim, Dashboard/Instrument Panel, Service and Repair,
Instrument Panel Assembly Replacement, See: Body and Frame/Interior Moulding / Trim/Dashboard / Instrument Panel/Service and
Repair/Instrument Panel Assembly
