Liberty Sport 2WD L4-2.4L VIN 1 (2002)
Low Pressure Sensor / Switch: Description and Operation
A/C LOW PRESSURE SWITCH
The A/C low pressure switch is located on the top of the accumulator The switch is screwed onto an accumulator fitting that contains a
Schrader-type valve, which allows the switch to be serviced without discharging the refrigerant system. The accumulator fitting is equipped with
an O-ring to seal the switch connection.
The a/c low pressure switch is connected in series electrically with the a/c high pressure switch, between ground and the Powertrain Control
Module (PCM). The switch contacts open and close causing the PCM to turn the a/c compressor clutch ON and OFF. This regulates the
refrigerant system pressure and controls evaporator temperature. Controlling the evaporator temperature prevents condensate water on the
evaporator fins from freezing and obstructing air conditioning system air flow.
The a/c low pressure switch contacts are open when the suction pressure is approximately 141 kPa (20.5 psi) or lower. The switch contacts will
close when the suction pressure rises to approximately 234 to 262 kPa (34 to 38 psi) or above. Lower ambient temperatures, below approximately
-1 °C (30 °F), will also cause the switch contacts to open. This is due to the pressure/temperature relationship of the refrigerant in the system.
The a/c low pressure switch is a factory-calibrated unit. It cannot be adjusted or repaired and, if faulty or damaged, it must be replaced.
