Liberty Sport 2WD L4-2.4L VIN 1 (2002)
Parking Brake Warning Lamp: Testing and Inspection
The diagnosis found here addresses an inoperative brake indicator condition. If there are problems with several indicators in the instrument cluster,
(Refer to INSTRUMENT CLUSTER - DIAGNOSIS AND TESTING). If the brake indicator stays ON with the ignition switch in the ON position and
the park brake released, or comes on while driving. If no brake system problem is found, the following procedures will help to locate a shorted or open
circuit, or a faulty park brake switch input. Refer to the appropriate wiring information. The wiring information includes wiring diagrams, proper wire
and connector repair procedures, details of wire harness routing and retention, connector pin-out information and location views for the various wire
harness connectors, splices and grounds.
WARNING: ON VEHICLES EQUIPPED WITH AIRBAGS, DISABLE THE SUPPLEMENTAL RESTRAINT SYSTEM BEFORE
ATTEMPTING ANY STEERING WHEEL, STEERING COLUMN, DRIVER AIRBAG, PASSENGER AIRBAG, SEAT BELT TENSIONER,
FRONT IMPACT SENSORS, SIDE CURTAIN AIRBAG, OR INSTRUMENT PANEL COMPONENT DIAGNOSIS OR SERVICE.
DISCONNECT AND ISOLATE THE BATTERY NEGATIVE (GROUND) CABLE, THEN WAIT TWO MINUTES FOR THE SYSTEM
CAPACITOR TO DISCHARGE BEFORE PERFORMING FURTHER DIAGNOSIS OR SERVICE. THIS IS THE ONLY SURE WAY TO
DISABLE THE SUPPLEMENTAL RESTRAINT SYSTEM. FAILURE TO TAKE THE PROPER PRECAUTIONS COULD RESULT IN
ACCIDENTAL AIRBAG DEPLOYMENT AND POSSIBLE PERSONAL INJURY.
Indicator Illuminates During Bulb Test, But Does Not When Park Brake Applied
1. Disconnect and isolate the battery negative cable. Disconnect the front body wire harness connector for the park brake switch from the switch
terminal. Apply the parking brake. Check for continuity between the park brake switch terminal and a good ground. There should be continuity. If
OK, go to Step 2. If not OK, replace the faulty park brake switch.
2. Disconnect the instrument panel wire harness connector for the instrument cluster from the cluster connector receptacle. Check for continuity
between the park brake switch sense circuit cavities of the front body wire harness connector for the park brake switch and the instrument panel
wire harness connector for the instrument cluster. There should be continuity. If not OK, repair the open park brake switch sense circuit between
the park brake switch and the instrument cluster as required.
Indicator Remains Illuminated - Brake System Checks OK
1. Disconnect and isolate the battery negative cable. Disconnect the front body wire harness connector for the park brake switch from the switch
terminal. Check for continuity between the terminal of the park brake switch and a good ground. There should be no continuity with the park brake
released, and continuity with the park brake applied. If OK, go to Step 2. If not OK, replace the faulty park brake switch.
2. Disconnect the instrument panel wire harness connector for the instrument cluster from the cluster connector receptacle. Check for continuity
between the park brake switch sense circuit cavity of the front body wire harness connector for the park brake switch and a good ground There
should be no continuity If not OK repair the shorted park brake switch sense circuit between the park brake switch and the instrument cluster as
required.
