Liberty Sport 2WD L4-2.4L VIN 1 (2002)
Fig.27 Headlamp Bulb Remove/Install
7. Pull the bulb straight out of the headlamp unit reflector.
INSTALLATION
North America
CAUTION:
-
Always use the correct bulb size and type for replacement. An incorrect bulb size or type may overheat and cause damage to the lamp, the socket
andlor the lamp wiring.
-
Do not contaminate the bulb glass by touching it with your fingers or by allowing it to contact other oily surfaces. Shortened bulb life will result.
1. Position the headlamp bulb and socket unit into the lock ring.
2. Reconnect the grille opening reinforcement wire harness connector for the headlamp bulb to the connector receptacle on the bulb socket.
3. Position the lock ring, socket, and bulb down behind the upper radiator crossmember and align them with the socket opening on the back of the
headlamp unit housing.
4. Push the socket and bulb straight into the headlamp unit housing until they are firmly seated.
5. Position the lock ring over the socket and engage it with the flange on the back of the headlamp unit housing.
6. Rotate the lock ring on the back of the headlamp unit housing clockwise about 30 degrees.
7. Reconnect the battery negative cable.
Rest-Of-World
CAUTION:
-
Always use the correct bulb size and type for replacement. An incorrect bulb size or type may overheat and cause damage to the lamp, the socket
andlor the lamp wiring.
-
Do not contaminate the bulb glass by touching it with your fingers or by allowing it to contact other oily surfaces. Shortened bulb life will result.
1. Position the bulb into the headlamp unit reflector.
2. Pivot the headlamp bulb retainer clip back over the bulb flange.
3. Pinch the two hooked ends of the wire headlamp bulb retainer clip together and engage them into the slots in the flange of the reflector.
4. Position the center opening of the boot seal over the base of the headlamp bulb and pull it downward until the seal is fully engaged over the bulb
base.
5. Position the outer circumference of the boot seal over the flange on the back of the headlamp unit housing and pull it downward until the seal is
fully engaged over the flange.
6. Reinstall the headlamp unit onto the grille opening reinforcement. (Refer to LAMPS/LIGHTING - EXTERIOR/HEADLAMP UNIT -
INSTALLATION).
7. Reconnect the battery negative cable.
8. Confirm proper headlamp unit alignment. (Refer to LAMPS/LIGHTING - EXTERIOR/HEADLAMP UNIT - ADJUSTMENTS).
