Liberty Sport 2WD L4-2.4L VIN 1 (2002)
1. Position front of starter towards rear of vehicle with solenoid position rotated until it is located below starter. Install starter by passing it between
exhaust pipe and transmission bellhousing.
2. Position starter into bellhousing and install 2 bolts. Refer to torque specifications.
3. Install battery cable and nut to stud on starter solenoid. Refer to torque specifications.
4. Install solenoid wire connector to solenoid terminal.
5. Position starter heat shield and install nut at front of starter.
6. Install 2 starter heat shield bolts at side of starter.
7. Install front propeller shaft.
8. Install 2 flange bolts securing left exhaust downpipe to crossover pipe
9. Lower vehicle
10. Connect negative battery cable
