Liberty Sport 2WD L4-2.4L VIN 1 (2002)
Control Arm Bushing: Service and Repair
Clevis Bracket Bushing
REMOVAL - CLEVIS BRACKET BUSHING
1. Remove the clevis bracket from the shock.
NOTE: Extreme pressure lubrication must be used on the threaded portions of the tool. This will increase the longevity of the tool and insure
proper operation during the removal and installation process.
2. Press the bushing out using special tools 8858-1 (receiver), 8858-3 (driver) and 8839 with the threaded rod 8839 and the bearing as shown
INSTALLATION - CLEVIS BRACKET BUSHING
NOTE: Extreme pressure lubrication must be used on the threaded portions of the tool. This will increase the longevity of the tool and insure proper
operation during the removal and installation process.
1. Install the new clevis bracket bushing into the lower control arm using tools 8858-2 (driver), 8858-1 (receiver) and the bearing with the threaded
rod 8839 making sure to properly orient the bushing in the control.
2. Install the clevis bracket.
