Liberty Sport 2WD L4-2.4L VIN 1 (2002)
Pilot Bearing: Service and Repair
PILOT BEARING / REMOVAL
1. Remove the transmission.
2. Remove pressure plate and clutch disc.
3. Remove pilot bearing with an internal (blind hole) puller.
INSTALLATION
1. Lubricate new bearing with Mopar high temperature bearing grease or equivalent.
2. Start new bearing into crankshaft by hand. Then Set hearing with clutch alignment tom (Fig. 5).
3. Lightly scuff sand flywheel surface with 180 grit emery cloth. Then clean surface with wax and grease remover.
4. Install clutch disc and pressure plate.
5. Install the transmission.
