Liberty Sport 2WD L4-2.4L VIN 1 (2002)
6. Using yoke with Spanner Wrench 6958 and a torque wrench set at 474 Nm (350 ft. lbs.), (Fig. 41) slowly tighten the nut in 6.8 Nm (5 ft. lbs.)
increments until the rotating torque is achieved. Measure the rotating torque frequently to avoid over crushing the collapsible spacer (Fig. 42).
NOTE: If more than 474 Nm (350 ft. lbs.) torque is required to crush the collapsible spacer, the spacer is defective and must be replaced.
7. Check rotating torque with an inch pound torque wrench (Fig. 42). The rotating torque of the pinion gear should be, the reading recorded during
removal plus an additional 0.56 Nm (5 in. lbs.).
8. Install propeller shaft with reference marks aligned.
9. Install rear brake drums.
10. Add gear lubricant, if necessary.
11. Install wheel and tire assemblies.
12. Remove supports and lower vehicle.
