Liberty Sport 2WD L4-2.4L VIN 1 (2002)
Drive/Propeller Shaft: Service and Repair
Removal and Installation
Propeller Shaft - Rear
REMOVAL
1. Shift the transmission/transfer case into Neutral.
2. Raise and support vehicle.
3. Mark a reference line across the pinion yoke and propeller shaft for installation.
4. Remove U-joint strap bolts at the pinion shaft yoke.
5. Pry open clamp holding the dust boot to propeller shaft yoke (Fig. 9), if equipped.
6. Slide slip yoke off of the transmission/transfer case output shaft and remove the propeller shaft (Fig. 10).
INSTALLATION
1. Slide slip yoke on the transmission/transfer case output shaft.
2. Align reference marks on the pinion yoke and propeller shaft.
3. Install U-joint straps and tighten bolts.
