Liberty Sport 2WD L4-2.4L VIN 1 (2002)
Windshield Washer Pump: Service and Repair
REMOVAL
1. Turn the front wheels full lock to the right.
2. Disconnect and isolate the battery negative cable.
3. Raise and support the vehicle.
4. Unsnap and lift the cover over the access hole at the front of the right front wheel house splash shield.
5. Place a clean container on the floor beneath the washer pump/motor location to catch any washer fluid that is spilled during the following
procedure.
6. Reach through the access hole and firmly grasp the top of the washer pump/motor housing.
Fig.20 Washer Pump/Motor Remove/Install
7. Pull lightly outward on the top of the washer pump/motor housing away from the washer reservoir far enough to disengage the snap post on the top
of the motor from the receptacle in the reservoir.
8. Pull the washer pump/motor unit straight out from the washer reservoir far enough to disengage the barbed pump inlet nipple from the rubber
grommet seal in the reservoir.
