Liberty Sport 4WD L4-2.4L VIN 1 (2002)
Front Fender Liner: Service and Repair
FRONT WHEELHOUSE SPLASH SHIELD
REMOVAL
1. Raise and support the vehicle. Refer to Vehicle Lifting.
2. Turn wheel as necessary to gain access to fasteners.
3. Remove the four rivets connecting the flare to the splash shield
4. Remove the rivet connecting the splash shield to the side sill molding.
5. Remove the three screw/rivets connecting the splash shield to the fascia.
6. Remove the four push pin fasteners and remove the splash shield.
INSTALLATION
1. Install the splash shield (1) and position above the wheel opening flare molding.
2. Install the four push pin fasteners (2 - 4).
3. Install the three screw/rivets connecting the splash shield to the fascia.
4. Install the four rivets connecting the flare to the splash shield
5. Install the rivet connecting the splash shield to the side sill molding.
