Liberty Sport 4WD L4-2.4L VIN 1 (2002)
Compass: Service and Repair
Compass/Mini-Trip Computer Bulb Replacement
REMOVAL
The Compass Mini-Trip Computer (CMTC) in the overhead console includes either two or three incandescent illumination bulb and bulb holder
units. Three bulbs are used only on models that also feature the optional Universal Garage Door Opener (UGDO).
WARNING: ON VEHICLES EQUIPPED WITH AIRBAGS, DISABLE THE SUPPLEMENTAL RESTRAINT SYSTEM BEFORE
ATTEMPTING ANY STEERING WHEEL, STEERING COLUMN, DRIVER AIRBAG, PASSENGER AIRBAG, SEAT BELT
TENSIONER, FRONT IMPACT SENSORS, SIDE CURTAIN AIRBAG, OR INSTRUMENT PANEL COMPONENT DIAGNOSIS OR
SERVICE. DISCONNECT AND ISOLATE THE BATTERY NEGATIVE (GROUND) CABLE, THEN WAIT TWO MINUTES FOR THE
SYSTEM CAPACITOR TO DISCHARGE BEFORE PERFORMING FURTHER DIAGNOSIS OR SERVICE. THIS IS THE ONLY SURE
WAY TO DISABLE THE SUPPLEMENTAL RESTRAINT SYSTEM. FAILURE TO TAKE THE PROPER PRECAUTIONS COULD
RESULT IN ACCIDENTAL AIRBAG DEPLOYMENT AND POSSIBLE PERSONAL INJURY.
1. Disconnect and isolate the battery negative cable.
2. Remove the overhead console from the headliner. (Refer to OVERHEAD CONSOLE - REMOVAL).
Fig.8 Compass Mini-Trip Illumination Bulb Remove/Install
3. From the back of the unit, use a small thinbladed screwdriver to rotate the compass mini-trip illumination bulb holder counterclockwise about 30
degrees on the circuit board (Fig. 8).
4. Pull the compass mini-trip illumination bulb holder and bulb unit straight out of the circuit board bulb mounting hole.
INSTALLATION
The Compass Mini-Trip Computer (CMTC) in the overhead console includes either two or three incandescent illumination bulb and bulb holder units.
Three bulbs are used only on models that also feature the optional Universal Garage Door Opener (UGDO).
WARNING: ON VEHICLES EQUIPPED WITH AIRBAGS, DISABLE THE SUPPLEMENTAL RESTRAINT SYSTEM BEFORE
ATTEMPTING ANY STEERING WHEEL, STEERING COLUMN, DRIVER AIRBAG, PASSENGER AIRBAG, SEAT BELT
TENSIONER, FRONT IMPACT SENSORS, SIDE CURTAIN AIRBAG, OR INSTRUMENT PANEL COMPONENT DIAGNOSIS OR
SERVICE. DISCONNECT AND ISOLATE THE BATTERY NEGATIVE (GROUND) CABLE, THEN WAIT TWO MINUTES FOR THE
SYSTEM CAPACITOR TO DISCHARGE BEFORE PERFORMING FURTHER DIAGNOSIS OR SERVICE. THIS IS THE ONLY SURE
WAY TO DISABLE THE SUPPLEMENTAL RESTRAINT SYSTEM. FAILURE TO TAKE THE PROPER PRECAUTIONS COULD
RESULT IN ACCIDENTAL AIRBAG DEPLOYMENT AND POSSIBLE PERSONAL INJURY.
CAUTION: Always use the correct bulb size and type for replacement. An incorrect bulb size or type may overheat and cause damage to the lamp,
the socket and/or the lamp wiring.
1. Align the compass mini-trip illumination bulb holder and bulb unit with the circuit board bulb mounting hole.
2. Insert the compass mini-trip illumination bulb holder and bulb unit straight into the circuit board bulb mounting hole until it is firmly seated (Fig.
8).
3. Using a small thin-bladed screwdriver, rotate the compass mini-trip illumination bulb holder clockwise about 30 degrees on the circuit board.
4. Reinstall the overhead console onto the headliner. (Refer to OVERHEAD CONSOLE - INSTALLATION).
5. Reconnect the battery negative cable.
