Liberty Sport 4WD L4-2.4L VIN 1 (2002)
Fog/Driving Lamp Bulb: Service and Repair
REMOVAL
1. Turn the front wheels full lock in the direction of the fog lamp bulb that is to be changed.
2. Disconnect and isolate the battery negative cable.
Fig.10 Front Fog Lamp Bulb Remove/Install
3. Reach into the front wheel opening to unsnap and lift the cover over the access hole at the front of the front wheelhouse splash shield.
4. Reach through the access hole and firmly grasp the socket on the back of the front fog lamp unit housing.
5. Rotate the socket on the back of the front fog lamp unit housing counterclockwise about 30 degrees.
CAUTION: Do not contaminate the bulb glass by touching it with your fingers or by allowing it to contact other oily surfaces. Shortened bulb life
will result.
6. Pull the socket and bulb straight out of the front fog lamp unit housing and through the access hole into the front wheel opening area.
7. Pull the bulb straight out of the front fog lamp unit socket.
INSTALLATION
CAUTION:
-
Always use the correct bulb size and type for replacement. An incorrect bulb size or type may overheat and cause damage to the lamp, the socket
andlor the lamp wiring.
-
Do not contaminate the bulb glass by touching it with your fingers or by allowing it to contact other oily surfaces. Shortened bulb life will result.
1. Align the base of the bulb with the receptacle in the front fog lamp unit socket.
2. Push the bulb straight into the front fog lamp unit socket until it is firmly seated.
3. Position the socket and bulb through the access hole in the front wheelhouse splash shield and align it with the socket opening on the back of the
front fog lamp unit housing.
4. Push the socket and bulb straight into the front fog lamp unit housing until it is firmly seated.
5. Rotate the socket on the back of the front fog lamp unit housing clockwise about 30 degrees.
6. Lower and snap shut the access cover over the hole at the front of the front wheelhouse splash shield.
7. Reconnect the battery negative cable.
