Liberty Sport 4WD L4-2.4L VIN 1 (2002)
intermediate detent that is one detent rearward (counterclockwise) from the full forward (clockwise) detent to select the low speed continuous
front wiper mode, or to its full forward (clockwise) detent to select the high speed continuous front wiper mode. The multi-function switch
provides a resistor multiplexed output to the Body Control Module (BCM) on a front wiper switch mux circuit, and the BCM responds by
energizing the wiper ON/OFF relay in the Power Distribution Center (PDC) for the front low speed continuous wipe mode, or the wiper
ON/OFF relay and the wiper high/low relay in the PDC for the front high speed continuous wipe mode as required.
-
Continuous Rear Wipe Mode - The control ring on the multi-function switch right (wiper) control stalk is rotated to the most forward
(clockwise) detent to select the continuous rear wiper mode. The multi-function switch provides a battery current output to the rear wiper
motor on a rear wiper on driver circuit to signal the rear wiper motor to operate in the continuous wipe mode.
-
Front Washer Mode - The right (wiper) control stalk of the multi-function switch is pulled towards the steering wheel to momentarily activate
the washer pump in the front washer mode. The washer pump will continue to operate in the front washer mode until the control stalk is
released. The multi- function switch provides a ground output on a washer pump sense circuit, and battery current on a washer pump driver
circuit to energize the washer pump in the front washer mode.
-
Front Wiper Mist Mode - The right (wiper) control stalk of the multi-function switch is pushed towards the floor to momentarily activate the
front wiper motor in the mist mode. The front wiper motor will continue to operate in the mist mode until the control stalk is released. The
multi-function switch provides a resistor multiplexed output to the Body Control Module (BCM) on a front wiper switch mux circuit, and the
BCM responds by energizing the wiper ON/OFF relay in the Power Distribution Center (PDC) to operate the front wiper motor momentarily at
low speed to provide the front wiper mist mode.
-
Intermittent Front Wipe Mode - The control knob on the end of the multi-function switch right (wiper) control stalk is rotated to one of five
minor intermediate detents to select the desired intermittent front wipe delay interval. The control knob is rotated rearward (counterclockwise)
to increase the delay, or forward (clockwise) to decrease the delay. The multi-function switch provides a resistor multiplexed output to the
Body Control Module (BCM) on a front wiper switch mux circuit, and the BCM responds by energizing the wiper ON/OFF relay in the Power
Distribution Center (PDC) to operate the front wiper motor at the selected delay intervals.
-
Intermittent Rear Wipe Mode - The control ring on the multi-function switch right (wiper) control stalk is rotated to the center detent to
select the intermittent rear wiper mode. The multi-function switch provides a battery current output to the rear wiper motor on a rear wiper
intermittent driver circuit to signal the rear wiper motor to operate in the intermittent wipe mode.
-
Rear Washer Mode - The control ring on the multi-function switch right (wiper) control stalk is rotated to either the full forward (clockwise)
or full rearward (counterclockwise) momentary positions to activate the washer pump in the rear washer mode. The washer pump will continue
to operate in the rear washer mode until the control ring is released. The multi-function switch provides a ground output on a washer pump
driver circuit, and battery current on a washer pump sense circuit to energize the washer pump in the rear washer mode.
