Liberty Sport 4WD L4-2.4L VIN 1 (2002)
mounting and disassembled. Refer to Wiring Repair in Wiring Diagrams for the location of the wiring repair procedures.
1. Remove the PDC housing lower cover.
2. From the top of the PDC housing, use a small screwdriver or a terminal pick tool (Special Tool Kit 6680) to release the two latches that secure the
B(+) terminal module in the PDC.
3. Gently and evenly press the two B(+) terminal studs down through the bus bar in the PDC.
4. From the bottom of the PDC housing, remove the B(+) terminal module from the PDC.
INSTALLATION
1. From the bottom of the PDC housing, align and insert the B(+) terminal module into the PDC.
2. From the bottom of the PDC housing, align and insert the two studs of the PDC B(+) terminal module through the bus bar in the PDC.
3. From the bottom of the PDC housing, press the B(+) terminal module gently and evenly into the PDC until both of the latches are fully engaged.
4. Install the PDC housing lower cover.
PDC Housing Lower Cover
Disassembly and Assembly
REMOVAL
The Power Distribution Center (PDC) cover, the PDC housing lower cover, the PDC relay wedges, the PDC mini fuse wedge, the PDC relay cassettes
and the PDC B(+) terminal stud module are available for service replacement. The PDC cover can be simply unlatched and removed from the PDC
housing without the PDC being removed or disassembled. Service of the remaining PDC components requires that the PDC be removed from its
mounting and disassembled. Refer to Wiring Repair in Wiring Diagrams for the location of the wiring repair procedures.
1. Unlatch and remove the cover from the PDC.
2. Remove the two nuts that secure the two-holed eyelet of the battery wire harness PDC take out to the B(+) terminal studs near the inboard end of
the PDC.
3. Remove the battery wire harness PDC take out eyelet from the two PDC B(+) terminal studs.
4. Disengage the latches on the PDC housing mounts from the tabs on the PDC mounting stanchions on the battery tray, and pull the PDC housing
upward to disengage the mounts from the stanchions.
5. Where the headlamp and dash wire harness exits the PDC, remove the tape that secures the wire harness to the trough formation on the PDC
housing lower cover.
Fig. 3 PDC Housing Lower Cover Remove / Install - Typical
6. Using a trim stick or another suitable wide flat-bladed tool, gently pry the latches on each side of the PDC housing that secure the housing lower
cover to the PDC and remove the housing lower cover.
INSTALLATION
