Liberty Sport 4WD L4-2.4L VIN 1 (2002)
Crankshaft Position Sensor: Service and Repair
REMOVAL
Fig.6 CKP Sensor Location - 2.4L
The Crankshaft Position (CKP) sensor is mounted into the right front side of the cylinder block. It is positioned and bolted into a machined hole.
1. Disconnect sensor electrical connector.
2. Remove sensor bolt.
3. Carefully pry sensor from cylinder block in a rocking action.
Fig.7 CKP And O-ring - 2.4L
4. Check condition of sensor O-ring.
INSTALLATION
1. Clean out machined hole in engine block.
2. Apply a small amount of engine oil to sensor O-ring.
3. Install sensor into engine block with a slight rocking action. Do not twist sensor into position as damage to O-ring may result.
CAUTION: Before tightening sensor mounting bolt, be sure sensor is completely flush to cylinder block. If sensor is not flush, damage to sensor
