Liberty Sport 4WD L4-2.4L VIN 1 (2002)
CAUTION:
Do not over tighten the vise, steering knuckle damage could occur.
16.
Remove and discard the lower ball joint boot and boot retaining clip (Figure 5).
CAUTION:
Failure to remove the ball joint boot and retaining clip before pressing the ball joint out of the steering knuckle will make ball joint removal difficult.
17.
Press the lower ball joint from the steering knuckle using special tool C-4212F (press), 8859-2 (receiver) and 8859-1 (driver) (Figure 6).
NOTE:
Make sure the receiver is centered over the ball joint before pressing the ball joint from the knuckle.
18.
Remove any debris from the ball joint bore located in the steering knuckle.
