Liberty Sport 4WD L4-2.4L VIN 1 (2002)
Wiper Motor: Service and Repair
REMOVAL
1. Disconnect and isolate the battery negative cable.
2. Remove the rear wiper arm from the rear wiper motor output shaft. (Refer to REAR WIPERS/WASHERS/REAR WIPER ARM - REMOVAL).
Fig.16 Rear Wiper Motor Output Shaft Nut Remove/Install
3. Using a small thin-bladed tool, gently pry at the notch in the base of the rear wiper motor output shaft bezel to unsnap the nut cover from the bezel.
Be certain to take proper precautions to protect the outer tailgate panel and its paint finish from damage during this procedure.
4. Remove the nut that secures the rear wiper motor output shaft to the outer swing gate panel.
5. Remove the bezel and gasket from the rear wiper motor output shaft.
6. Remove the trim panel from the tailgate inner panel.
7. Disconnect the tailgate wire harness connector for the flip-up glass ajar switch from the flip-up glass latch connector receptacle.
Fig.17 Rear Wiper Motor Remove/Install
