Patriot 2WD L4-2.0L (2008)
Rear Door Panel: Service and Repair
Rear Door Module Trim - Installation
INSTALLATION
1. Position the wire harness door bracket (2) into the door and install the screws (3).
2. Position the latch into the door and set the trim module (1) into place.
3. Position the four trim hooks (2) and lower the regulator screw (4) into the corresponding slot (3) in the door and seat the trim module fully.
4. Install the upper regulator screws (1) and tighten to 6 Nm (53 in. lbs.).
