Patriot 2WD L4-2.0L (2008)
NOTE: Once the caliper is installed, inspect the outboard brake pad to make sure it is correctly positioned. The retaining clip (2) must be
squarely seated in the depressed areas (1) on the caliper fingers. Also, the nubs on the pad's steel backing plate must be fully seated in the
depressions formed into the inside of the caliper fingers. There should be no gap between the pad backing plate and the caliper fingers.
5. Thread the rear brake flex hose (4) into the brake caliper (1). Tighten the flex hose fitting at the caliper to 15 Nm (133 in. lbs.).
6. Route and install the brake flex hose into the trailing link mounted bracket. Install the clip (3) securing the flex hose to the bracket.
7. Thread the brake tube nut (2) into brake flex hose. Tighten the brake tube nut to 17 Nm (150 in. lbs.).
