Patriot 2WD L4-2.0L (2008)
4. Rotate the disc brake caliper downward over the brake rotor and lower part of caliper adapter.
5. Install the disc brake caliper (2) lower guide pin bolt (1). Tighten the guide pin bolt to 43 Nm (32 ft. lbs.).
NOTE: Once the caliper is installed, inspect the outboard brake pad to make sure it is correctly positioned. The retaining clip (2) must be
squarely seated in the depressed areas (1) on the caliper fingers. Also, the nubs on the pad's steel backing plate must be fully seated in the
depressions formed into the inside of the caliper fingers. There should be no gap between the pad backing plate and the caliper fingers.
