Patriot 2WD L4-2.0L (2008)
CAUTION: When installing the vacuum hose on the check valve (1), make sure the hose is routed properly to avoid possible contact with
unfriendly surfaces.
9. Connect the vacuum hose (2) to the vacuum check valve (1).
10. Install the master cylinder. See: Hydraulic System/Brake Master Cylinder/Service and Repair/Removal and Replacement/Master Cylinder -
Installation
11. Connect the battery negative cable to its post on the battery.
12. Bleed the base brake system if necessary. See: Brake Bleeding
WARNING: Be certain a firm brake pedal is achieved prior to attempting to operate the vehicle.
13. Road test the vehicle to ensure proper operation of the brakes.
