Patriot 2WD L4-2.0L (2008)
Connecting Rod Bearing: Service and Repair
Connecting Rod Bearing Fitting
CONNECTING ROD - FITTING
There are three different sizes of rod bearings available. Connecting rod bearing identification (4) can be found on the nose of the crankshaft (3). Use the
table below for proper bearing selection.
1. For measuring connecting rod bearing clearance procedure and use of PlastigageSee: Service and Repair/Procedures/Measuring Bearing Clearance
Using Plastigage. For bearing clearance See: Specifications/Engine Specifications.
NOTE: The rod bolts should not be reused.
2. Before installing the NEW rod bolts the threads and under the bolt head should be oiled with clean engine oil.
3. Install each bolt finger tight then alternately tighten each bolt to assemble the cap properly.
4. Tighten the connecting rod bolts using the 2 step torque-turn method. Tighten according to the following values:
CAUTION: Do not use a torque wrench for the second step.
-
Tighten the bolts to 20 Nm (15 ft. lbs.).
-
Tighten the connecting rod bolts an additional 90°.
