Patriot 2WD L4-2.0L (2008)
Parking Light Bulb: Service and Repair
Removal
BULB
1. Disconnect and isolate the battery negative cable.
2. Raise and support the vehicle.
3. Remove the front wheel and tire on the same side of the vehicle as the park/turn signal lamp being serviced. See: Maintenance/Wheels and
Tires/Service and Repair/Removal and Replacement/Tires and Wheels - Removal.
4. Remove the three screws (1) that secure the outboard side of the front wheel house splash shield (4) to the front fascia (2).
5. Remove the push pin fastener (3) that secures the inboard side of the splash shield to the front end sheet metal.
6. Remove the two push pin fasteners that secure the forward edge of the splash shield to the front fascia closure panel.
7. Fold the front of the splash shield rearward far enough to access the back of the front fascia.
8. From behind the front fascia (3) disconnect the engine compartment wire harness connector (2) from the park/turn signal bulb socket (1) connector
receptacle.
9. Firmly grasp the bulb socket on the back of the park turn signal lamp housing (4) and rotate it counterclockwise about 30 degrees to unlock it.
10. Pull the socket and bulb straight out from the keyed opening in the housing.
11. Pull the base of the bulb straight out of the socket.
