Patriot 2WD L4-2.0L (2008)
6. Remove the second row center seat belt and retractor unit from the right quarter inner panel.
Second Row Outboard
SECOND ROW OUTBOARD
WARNING: To avoid serious or fatal injury during and following any seat belt or child restraint anchor service, carefully inspect all seat belts,
buckles, mounting hardware, retractors, tether straps, and anchors for proper installation, operation, or damage. Replace any belt that is cut,
frayed, or torn. Straighten any belt that is twisted. Tighten any loose fasteners. Replace any belt that has a damaged or ineffective buckle or
retractor. Replace any belt that has a bent or damaged latch plate or anchor plate. Replace any child restraint anchor or the unit to which the
anchor is integral that has been bent or damaged. Never attempt to repair a seat belt or child restraint component. Always replace damaged or
ineffective seat belt and child restraint components with the correct, new and unused replacement parts listed in the DaimlerChrysler
Mopar(R) Parts Catalog.
NOTE: All seat belt retractors except the driver side front retractor include a switchable automatic locking mechanism. See: Description and
Operation/Description.
1. Remove the rear seat cushion from the vehicle. See: Body and Frame/Seats/Seat Cushion/Service and Repair/Removal and Replacement/Seat
Cushion - Removal.
2. Remove the screw (4) that secures the second row outboard seat belt lower anchor to the rear floor panel (3).
3. Remove the upper trim (2) from the inside of the C-pillar (6). See: Body and Frame/Interior Moulding / Trim/Trim Panel/Service and Repair/Pillar
Trim/C-Pillar Trim Panel-Removal.
4. Pull the seat belt lower anchor through the seat belt opening in the upper C-pillar trim.
5. Remove the screw (1) that secures the seat belt turning loop to the upper C-pillar.
6. Remove the seat belt turning loop from the upper C-pillar.
7. Move the trim from the front of the quarter inner panel far enough to access the seat belt retractor (7). See: Body and Frame/Interior Moulding /
Trim/Console/Service and Repair/Console Shifter Bezel - Removal.
8. Remove the screw (4) that secures the retractor (1) to the lower C-pillar.
9. Remove the second row outboard seat belt and retractor from the lower C-pillar as a unit.
