Patriot 2WD L4-2.0L (2008)
CAUTION: Seal must not be dimpled, stretched, or out-of-shape in any way. If seal is NOT shaped correctly, equalize pressure in seal and
shape it by hand.
9. Position outer CV joint sealing boot (4) into its retaining groove on outer CV joint housing. Install sealing boot to outer CV joint retaining clamp
(1) evenly on sealing boot.
10. Clamp sealing boot onto outer CV joint housing using Clamp C-4975-A (3) and the following procedure. Place Clamp C-4975-A over bridge of
clamp (1).
11. Tighten nut on Clamp C-4975-A until jaws on tool are closed completely together (4), face to face.
12. Install the halfshaft requiring boot replacement back on the vehicle. See: Service and Repair/Half Shaft - Installation
