Patriot 2WD L4-2.0L (2008)
11. If the bearing race is still pressed onto the hub, install the Bearing Splitter (5), Special Tool 1130, between the hub flange and the bearing inner
race (4).
12. Place the hub, bearing race and Bearing Splitter in an arbor press. The press support blocks must not obstruct the wheel hub while it is being
pressed out of the bearing race.
13. Place Remover/Installer (2), Special Tool 9712-2, in the end of the hub (3). Lower the arbor press ram (1) and remove the hub from the bearing
race.
NOTE: For installation, See: Front Hub / Bearing - Installation.