Patriot 2WD L4-2.0L VIN 0 (2007)
3. Install each bolt finger tight then alternately torque each bolt to assemble the cap properly.
4. Tighten the connecting rod bolts using the 2 step torque-turn method. Tighten according to the following values:
CAUTION: Do not use a torque wrench for the second step.
-
Tighten the bolts to 20 Nm (15 ft. lbs.).
-
Tighten the connecting rod bolts an additional 90°.
5. Using a feeler gauge, check connecting rod side clearance. Refer to clearance specifications.
