Patriot 2WD L4-2.4L (2009)
4. Position the seat belt (3) lower anchor to the mounting hole on the outboard side of the front seat cushion frame. Be certain that the seat belt
webbing between the turning loop and the lower anchor is not twisted.
5. Install and tighten the screw (2) that secures the lower anchor to the seat. Tighten the screw to 51 Nm (37.5 ft. lbs.).
6. Install the lower anchor cover (1) onto the front seat cushion outboard side shield (4).
Upper
INSTALLATION
1. Align the upper tab and position the upper B-pillar trim (1) into place and seat the trim fully.
2. Install and tighten the screw (3) that secures the turning loop to the height adjuster. Tighten the screw to 40 Nm (30 ft. lbs.).
3. Position the lower B-pillar trim (2) into place and seat fully.
Lower
REMOVAL
1. Adjust the front seat to its most forward position for easiest access to the front seat belt lower anchor cover (1) and the B-pillar trim.
2. Grasp the upper edge of the lower anchor cover and pull upward to unsnap it from the front seat cushion outboard side shield (4).
3. Remove the screw (2) that secures the seat belt (3) lower anchor to the outboard side of the front seat cushion frame.
