Patriot 2WD L4-2.4L (2009)
5. At the rear roof panel apply Kent Hi-Tech Seam Sealer P10200 or equivalent around the patch shown in (Fig. 11) on the right and left side.
6. Allow the sealer to fully cure per adhesive manufacturers recommendations.
7. Install the right an/or left roof ditch molding(s).
NOTE:
When installing the roof ditch molding apply firm pressure to the molding so proper wet is achieved to insure proper adhesion.
VERIFICATION PROCEDURE:
1. Perform a water flow test and verify there are no water leaks.
2. Return the vehicle to the customer.
POLICY:
Reimbursable within the provisions of the warranty.
