Patriot 2WD L4-2.4L (2009)
2. Through the opening in the bottom of the quarter trim panel, disconnect the wheel speed sensor cable connector (2) at the body wiring harness
connector (3).
3. Raise and support the vehicle. See: Maintenance/Vehicle Lifting/Service and Repair.
4. Remove the wheel mounting nuts (3), then the rear tire and wheel assembly (1).
5. Remove the grommet (2) from the hole in the body (1) and pull the wheel speed sensor cable out through the hole.
6. Remove the speed sensor cable routing clip (3) from the outside frame rail (4).
