Patriot 2WD L4-2.4L (2009)
1. Disconnect and isolate the battery negative cable.
2. Remove the repeater lamp from the fender mounting hole, but do not disconnect the wire harness connector. See: Service and Repair/Side
Repeater Lamp - Removal.
3. Firmly grasp the bulb socket (1) on the back of the lamp lens/housing (4) and rotate it counterclockwise about 30 degrees to unlock it.
4. Pull the socket and bulb straight out from the keyed opening in the housing.
5. Pull the base of the bulb (3) straight out of the socket.
Side Repeater Lamp Bulb - Installation
BULB
CAUTION: Always use the correct bulb size and type for replacement. An incorrect bulb size or type may overheat and cause damage to the
lamp, the socket or the lamp wiring.
NOTE: Repeater lamps are used only on vehicles manufactured for certain markets where these lamps are required.
1. Align the base of the bulb (3) with the socket (1).
2. Push the bulb straight into the socket until the base is firmly seated.
3. Be certain that a rubber O-ring seal (2) is properly installed and in good condition around the base of the bulb socket.
4. Align the socket and bulb with the keyed opening on the back of the repeater lamp lens/housing (4).
5. Insert the socket and bulb into the housing until the socket is firmly seated.
6. Rotate the socket clockwise about 30 degrees to lock it into place.
7. Reinstall the repeater lamp into the fender mounting hole. See: Service and Repair/Side Repeater Lamp - Installation.
8. Reconnect the battery negative cable.
Tail Stop Turn Lamp Bulb - Removal
BULB - DOMESTIC
