jeep Workshop Repair Guides

Jeep Workshop Service and Repair Manuals

Towing Information > < Jump Starting|Service and Repair
Page 2
background image

Make sure you have a good contact.

8. If the vehicle is equipped with Sentry Key Immobilizer, turn the ignition switch to the ON position for 3 seconds before moving the ignition switch

to the START position.

9. Start the engine in the vehicle that has the booster battery, let the engine idle a few minutes, then start the engine in the vehicle with the discharged

battery.

CAUTION: Do not crank starter motor on disabled vehicle for more than 15 seconds, starter will overheat and could fail.

10. Allow battery in disabled vehicle to charge to at least 12.4 volts (75% charge) before attempting to start engine. If engine does not start within 15

seconds, stop cranking engine and allow starter to cool (15 minutes), before cranking again.

11. When removing the jumper cables, reverse the sequence exactly. Be careful of the moving belts and fan.

Towing Information > < Jump Starting|Service and Repair