Patriot 2WD L4-2.4L (2009)
Engine Control Module: Procedures
TCM Initialization
TRANSMISSION CONTROL MODULE INITIALIZATION
NOTE: Refer to the following table when the Transmission Control Module (TCM) and/or transaxle has been replaced to determine if the
TCM memory must be erased.
INITIAL LEARN (BRAND-NEW MODULE, MEMORY ALREADY CLEAR)
Battery must be connected. If the Totally Integrated Power Module (TIPM) is to be configured, configure the TIPM and then turn ignition key to
OFF/LOCKED briefly, then back to RUN. The shifter must be in PARK or NEUTRAL, engine not running.
1. Turn the ignition key to RUN for 4 seconds to allow reading of new values.
2. Turn ignition key to OFF/LOCKED for 2 seconds to allow storing new values in EEROM.
3. Turn the ignition key to RUN, with scan tool clear DTCs.
4. Turn ignition key to OFF/LOCKED for 2 seconds.
5. After at least 7 seconds, read DTCs.
6. If DTCs resets See: Transmission and Drivetrain/Continuously Variable Transmission/Transaxle/Testing and Inspection
RELEARN, AFTER REPLACING A TRANSAXLE
1. Turn ignition key to RUN.
2. Clear learning memory using the scan tool.
3. Turn the ignition key to OFF/LOCKED for 2 seconds.
4. Turn the ignition key to RUN Clear DTCs.
5. Turn the ignition key to OFF/LOCKED for 2 seconds.
6. Turn ignition key to RUN.
7. After at least 7 seconds, read DTCs.
8. If DTCs resets See: Transmission and Drivetrain/Continuously Variable Transmission/Transaxle/Testing and Inspection
PCM/TCM Reprogramming
PCM / TCM PROGRAMMING
PCM / TCM FLASH PROGRAMING
This procedure will need to be done when one or more of the following situations are true:
1. A vehicle's Powertrain Control Module (PCM) has been replaced.
2. A diagnostic trouble code (DTC) is set P1602 - PCM Not Programmed.
3. An updated calibration or software release is available for either the PCM or TCM ECUs.
This procedure assumes that the wiTECH(TM) Vehicle Connection Interface (VCI) pod, StarSCAN(R) and StarMOBILE(R) devices are configured to
your dealership's network with either a wired or wireless connection. The wiTECH(TM) VCI pod, StarSCAN(R) and StarMOBILE(R) must also be
running at the latest operating system and software release level. For more help on how to network your StarSCAN(R) or StarMOBILE(R) reference the
StarSCAN(R) / StarMOBILE(R) Quick Start Networking Guide available on 'DealerCONNECT > Service > StarSCAN(R) and StarMOBILE(R) Tools
> Online Documentation', under the Download Center. For the wiTECH(TM) VCI pod use the "HELP" tab in the wiTECH(TM) Diagnostic Application.
Table of contents
1. SECTION 1 - PCM / TCM FLASH PROCEDURE SECTION 1 - PCM / TCM FLASH PROCEDURE
2. REQUIRED TOOLS/EQUIPMENT REQUIRED TOOLS/EQUIPMENT:
3. TECH TIPS and INFORMATION TECH TIPS and INFORMATION:
4. PARTS REQUIRED PARTS REQUIRED