Patriot 2WD L4-2.4L (2009)
Seat Position Sensor: Service and Repair
Seat Track Position Sensor - Removal
REMOVAL
WARNING: To avoid serious or fatal injury on vehicles equipped with airbags, disable the Supplemental Restraint System (SRS) before
attempting any steering wheel, steering column, airbag, seat belt tensioner, impact sensor, or instrument panel component
diagnosis or service. Disconnect and isolate the battery negative (ground) cable, then wait two minutes for the system capacitor to
discharge before performing further diagnosis or service. This is the only sure way to disable the SRS. Failure to take the proper
precautions could result in accidental airbag deployment.
1. Disconnect and isolate the battery negative cable. Wait two minutes for the system capacitor to discharge before further service.
2. Reach under the front seat cushion to access the seat track position sensor (2) on a bracket located on the outboard side near the rear of the upper
outboard seat track (3).
3. Using a small screwdriver, hold the latch feature (4) depressed while sliding the connector end of the sensor off of the bracket.
4. Disconnect the seat wire harness connector (1) from the sensor connector receptacle.
5. Remove the sensor from under the front seat.
